MR8100

MR8100 – UNIDEN Scanning Mobile Receiver 8100


Error messages


Failure to initialize serial port!

There is something wrong with your PC’s serial port. It could be a hardware fault, or you attempted to use COM2 when in fact the PC is only configured for COM1.


Radio link failed!

The PC has waited too long for a response from the scanner – or unexpected data was received. Check cable connections and ensure that only the MR8100 and no other serial device is connected to the PC.


Improper radio response!

The MR8100 is not in a proper operating mode. This occurs primarily when the MR8100 is locked on to the priority channel. To remedy, turn off the priority scanning mode by pressing “PRI” on the radio’s keyboard.


Attempting to link to radio... Unsuccessful!

The MR8100 does not seem to be responding to the PC’s requests. Among possible causes is improper cable connection or inoperative radio.


Printer not ready!

This condition is encountered when there is no printer connected to the PC’s parallel port, or the printer is not turned “on”, or it is not “on line” or “selected”. Ensure that the printer is connected and fully functional (eg. paper available).


Printer not responding!

The printer encountered a problem while printing. This could be due to running out of paper, or an improper cable connection. Re-initiate the printout when everything checks out.


[<<]  [1]  [2]  [3]  [4]  [5]  [6]  [7]  [8]  [>>]


[Scanner Specifications]  [Technical Observations]  [Uniden Supplied Software]  [Custom Software Advantages
[Data Protocol]  [Interface Software]  [Birdie List]  [Service Manual]  [Related Links]

Back to menu page.